Video Input; Input Source Selection (Video, S-Video) - Sanyo PLC-XU300 Owner's Manual

Video Input

Input Source Selection (Video, S-video)

Direct Operation
Choose Video or S-video by pressing the INPUT button on
the top control, or the VIDEO button or the S-video button
on the remote control.
Before using INPUT button, correct input source should be
selected through menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point

Use the Point
ed
S-video and then press the SELECT button.
When video input signal is connected to the
Video
VIDEO jack, select Video.
When video input signal is connected to the S-
S-video
VIDEO jack, select S-video.
✔ Note:
When the Input Search function is set to On1 or On in
the Auto setup function, the input signal will be searched
automatically (p.45).
buttons to select Input and
ed
the SELECT button.
8 or
buttons to select either Video or
INPUT button
Top Control
(Component) / (RGB(Scart))
Remote Control
VIDEO button
S-video button
Input Menu
Computer 1(RGB) /
Computer (RGB)
Video
S-video
Video
S-video
37