D&H DH05C User Manual page 28

Reading out the extended characteristic values is executed by the entry of the character sequence
and by pressing the programming key.
Writing of the extended characterictic values is executed by the entry of the character sequence
and by pressing the programming key.
Notice:
Coreless motors should be operated with regulation variant 4 and pulse width 1.
No warranty for damages due to incorrect adjustments.
Caution!
Reading out and entering exctended characteristic values overwrite the default values of the decoder. In case you
have varied the extended characteristic values; the defaul characteristic value of the decoder must be entered
again.
Advice for decoder DH05C, DH10C, DH14B, DH18A, DH21A and FH18A:
For SX1-programming a connected SUSI-sound module must be removed. It is sufficient to interrupt the supply
voltage (red wire) during the time of SX1-programming. SX2- respective DCC-programming and D&H sound
modules are not concerned.
Decoder DH12A, DH16A, DH22A, FH05B und FH22A support SX1-programming also by connected SUSI-sound
module (ZVS available!). This only applies to DH21A if the SUSI-interface will be connected over the soldered
pads onto the decoder!
00–111
00=VAI
28