D&H DH05C User Manual page 16

9 In case your locomotive is not equipped with an interface jack, the decoders must be wired individually. For this
purpose you should use the decoders with flexible wires (DH05C-3, DH10C-3, DH16A-3, DH21A-3, PD05A-3,
PD12A-3).
10 The decoders DH05C-0, DH10C-0, DH16A-0, DH21A-0, PD05A-0 and PD12A-0 should be used by experienced
model railroaders only, as the connection wires must be soldered directly onto the decoder.
For above variant 9 connect the decoder wires according to the following diagram (see also the chart on the following
page):
red wire with the right track wire
black wire with the left track wire
orange wire with the motor wire, which was connected to the right track wire
gray wire with the motor wire, which was connected to the left track wire
white wire with the front light in driving direction
yellow wire with the rear light in driving direction
green wire function output AUX1 (only DH16A-2/3 and DH21A-2/3)
violet wire function output AUX2 (only DH16A-3 and DH21A-3)
blue wire common return, can carry up to 30 volts (+VS) (only DH16A-2/3 und DH21A-2/3)
In addition for SUSI-interface (only if available):
red wire SUSI-supply voltage (ZVS)
blue wire SUSI-clock (ZCLK)
gray wire SUSI-data (ZDAT)
black wire SUSI-ground (GND)
16