Filter replacement
Filter removal
• Isolate the water supply to the Boiling Water Appliance.
• Hold down tap cold lever to relieve the water pressure in the appliance.
• Switch off the power to the appliance and withdraw plug from wall.
• If a Rheem Chiller is connected to the Boiling Water Appliance, disconnect
all electrical connec ons from the Boiling Water Appliance to the Rheem
Chiller to prevent the Chiller from dispensing water during the filter
flushing procedure.
• Place a rag or paper towels beneath the filter to catch any spilled water
and prevent the inbuilt leak detector from ac va ng and shu ng the
appliance down.
• To remove the old filter cartridge, turn filter cartridge to the le as shown
un l rota on stops (1/4 turn). Pull cartridge downwards and out of head.
• Mop up any spilled water.
Filter replacement
• Align lugs on filter cartridge neck so that one is to the front.
• Press filter cartridge firmly into filter head.
• Turn filter cartridge to the right un l rota on stops (1/4 turn).
Filter flushing
• If a chiller is connected to the Boiling Water Appliance, disconnect the
Filtered Water pipe from the Boiling Water Appliance to the chiller at the
chiller inlet. Direct the pipe into a bucket.
• Turn water on to the Boiling Water Appliance.
• Turn the electricity to the Appliance back
on.
• Flush the new water filter by ac va ng the
cold bu on on the Tap for a minimum of
five minutes (note: the con nuous draw off
me can be increased to one minute
intervals).
• Once flushing is complete, reconnect the
Filtered Water pipe to the chiller.
• If a Rheem Chiller is installed, switch off
power and reconnect the electrical
connec ons from the Chiller to the Boiling
Water Appliance.
• Check Appliance is func oning correctly
and dispose of the old filter cartridge
responsibly.
NOTE: If no chiller is present the filter
can
be
flushed
Dispensing Tap without the removal of
any pipes.
14
through
the