Rheem 743 Series Owner's Manual & Installation Instructions page 12

Underbench boiling water appliances
Table of Contents

Advertisement

Temp Show ON/OFF
Selec ng  ON  displays  the  current  boiling  water  and 
chilled water temperatures on the main screen.
Up => Temp Show ON/OFF => Accept
Display Shows: OFF Press Up
Display Shows: ON
Note:  Chilled  water  temperature  is  only  displayed 
when a Rheem Chiller is connected.
TB Treq
Display boiling water calibra on temperature.
Up => TB Treq => Accept
Display Shows: TB xx ° C   Treq xx ° C
Chiller Select
Prog => Chiller Select => Accept
Display Shows: Auto
Press UP to select required mode:
i) Auto mode
Select to allow automa c detec on of Chiller.
ii) No Chiller mode
This allows the user to a ach a standalone chiller to the 
Boiling  Water  Unit.  By  ac va ng  the  'No  Chiller  mode', 
the  cold  lever  will  deliver  filtered  mains  temperature 
water to either a separate chiller or straight to the Tap.
iii) Push Through Chiller mode
If  the  unit  incorrectly  senses  the  appropriate  chiller,  the 
user can manually set the unit to a push through chiller.
iv) Pumped Chiller mode
If  the  unit  incorrectly  senses  the  appropriate  chiller,  the 
user can manually set the unit to a pumped chiller.
Chiller Temp
Set chilled water temperature.
Prog => Chiller Temp => Accept
Display Shows: xx ° C
Press Up to select temperature.
Se able Range 5° to 15°C.
Cold Tap Time
Set chilled water delivery  me.
Prog => Cold Tap Time => Accept
Display Shows: xx s
Press Up to select  me.
Se able Range 5 to 60 seconds.
Hot Tap Time
Set boiling water delivery  me.
Prog => Hot Tap Time => Accept
Display Shows: xx s
Press Up to select  me.
Se able Range 5 to 20 seconds.
Key Lock
When enabled bu ons are locked and user cannot make 
selec ons.
Prog => Key Lock => Accept
Display Shows: Key Lock Enable
Press Accept to enable key lock
To  unlock,  push  Prog  and  Up  bu ons  simultaneously 
for 10 seconds.
ERROR CODES
A
Boiling Water Thermistor Fault
B
Chilled Water Thermistor
C
Element Triac Fault
D
Leak Detected
E
Expired Filter
G
Calibra on Time Out
H
Low Level Probe Fault
J
High Level Probe Fault
K
Compressor Fault
L
Water Hea ng Fault
N
Excessive Temperature Rise
11

Advertisement

Table of Contents
loading

Table of Contents