LifeWalker Mobility Products Upwalker User Manual page 18

outside and the retaining nut on the inside. Slide bolt
with knob back through the holes on clamp and turn
the knob clockwise to seat the bolt in the retaining nut
and tighten clamp against frame. Re-attach the cup
and turn to desired position.
The upper retaining clamp attaches to the curved front
leg tube of frame, with clamp and gray knob on the
outside of the frame (Fig M17). To attach the clamp,
remove bolt with knob from the clamp. Spread the "U"
clamp over the frame with the knob on outside of
frame. Slide bolt with knob back through the holes on
clamp turning knob clockwise to tighten clamp against
frame. After attachment, turn retaining clamp to desired position to secure
cane or umbrella.
● Safety Flashlight / Taillight can be attached to the left
or right handgrip tubes (Fig M18) facing forward as a
headlight (Fig M19) or backward as a taillight. As with
other accessories, there is a "U" clamp which must be
spread open so as to place the clamp on the handgrip
tube with the light on the outside and holes for bolt on
the inside. Unscrew and remove the bolt and knob to
open clamp, attach clamp over tube and replace bolt
and knob with the bolt sliding in from the top and the
knob on the bottom of clamp.
Once attached you may aim the light in a downward
position to illuminate area in front of you or turn and
aim behind you so others can see you. The light is
turned on by depressing the button found on the back.
Push once for light to stay on; push a second time to
blink like a strobe light; push a third time to turn off.
The lens on the front of the light can be moved
outward or inward to change the size and shape of the
light beam. To insert the three AAA batteries (not included),
unscrew the cap on the back of the light, remove battery
holder and insert batteries in holder with batteries properly aligned with +/-
signs. Insert battery holder back into flashlight and resecure the cap.
18
Fig M17
Fig M18
Fig M19