Accessories - LifeWalker Mobility Products Upwalker User Manual

M. Accessories
The UPWalker is shipped to customers with the following standard

accessories:

● Backrest Support (Fig M1) is attached by sliding each end over the
sit-to-stand assist handles (Fig M2) with mesh material facing the rear end
of the UPWalker. Backrest may be left permanently on the UPWalker or
removed when not in use.
● Personal Item Bag (Fig M3) has Velcro straps which go over the handgrip
tubes at the bent sections (located below handgrips) and attach to the
opposite-side Velcro (Fig M4). The UPWalker logo is designed to be on the
front side of the bag facing away from you when using the UPWalker.
● Beverage Holder (Fig M5) can be attached to either one of the handgrip
tubes. First, unscrew the knob on U-shaped tube clamp and remove the
beverage holder from the U-clamp. Then slide "U" over handgrip tube (Fig
M6) close to armrest pad with hole on bottom and flat side of "U" facing
inward. Make sure rubber sleeve remains inside the "U". Slide the bolt on
beverage holder through the hole on "U" with beverage holder positioned
on the outside and the knob on the inside of the UPWalker (Fig M7). Note
Backrest
Fig M1
Fig M3
Fig M2
Fig M4
15