LifeWalker Mobility Products Upwalker User Manual page 17

● Smartphone Holder (Fig M12) supports different sizes of
phones for handsfree operation when you are on the go.
To attach the holder, first unscrew the cam lever nut
under the right armrest pad opposite the chrome cam
lever which secures the handgrip tube. Mate the hole in
the end of the flexible phone holder arm with the cam
lever bolt and the plastic base holding that bolt. Re-
attach and tighten the nut (Fig M13). Close cam lever to
secure both handgrip arm and smart phone holder. It
may be necessary to adjust the cam lever tension by
Fig M12
turning the cam lever nut clockwise or counterclockwise.
Two round adjuster knobs are located on the back of the
smart phone holder (Fig M14). Use the larger knob to
adjust the size of the holder to accommodate different
sizes of phones. Turn large knob counterclockwise to
open and insert phone, then turn knob clockwise to close
holder. Secure the phone in place by turning the small
knob clockwise. The phone holder is attached to a
flexible arm which can be bent to turn phone to desired
position (hold arm firmly where it attaches under
Fig M13
armrest while bending phone end, so as not to
break the attachment mechanism on the
UPWalker). The phone holder can be pivoted
on the flexible arm to optimize viewing of the
phone. Untighten/tighten the adjuster knob at
the end of the arm to pivot the phone holder.
● Cane/Umbrella Holder (Fig M15) attaches to
the side of the UPWalker for the convenience
Fig M14
of holding a cane or umbrella
handsfree. The cup attaches to the
lower horizontal frame tube facing
outward near front wheels (Fig M16).
To attach the cup, first turn the cup
to remove from the cup attachment
clamp. Then remove the bolt with
light gray knob from the clamp.
Spread the "U" clamp over the lower
horizontal tube with the knob on the
Fig M15 Fig M16
17