Sanyo PLC WXU700A Owner's Manual page 41

Input Source Selection (Component, RGB Scart 1-pin, HDMI)
Direct Operation
Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER button on the
remote control; choose HDMI by pressing the INPUT button on the top control or press the HDMI button on the
remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
Remote Control
COMPUTER button
COMPUTER  can not be selected when using the COMPUTER IN 2/

MONITOR OUT terminal as MONITOR OUT output.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
then press the Point
►

Use the Point buttons to select Computer 1 and
▲▼
then press the Point
►
buttons to select HDMI, and then press the SELECT
button.
3
When Computer 1 is selected, use the Point
buttons to select Component or RGB(Scart) and then
press the SELECT button.
When the input source is coming from video
Component
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
When the video signal is connected to the
HDMI
HDMI terminal, select HDMI.
Note:
• Network is for the Network function. See the owner's
manual of "Network Set-up and Operation" .
• When the Input Search function is set to On1 or On,
the input signal will be searched automatically (p.48).
HDMI button
HDMI
Computer 1
Computer 

buttons to select Input and
▲▼
or the SELECT button.
button; use the Point
▲▼
▲▼
INPUT button
Top Control
Input Menu
Video Input
Computer 1
Computer 

HDMI
Video
S-video
Network
41