Advertisement
Figure 10. Re-install Battery Retaining Bracket and Remove Tie-Wraps
11. Install the adapter on the UPS side battery harness (see
harness (red–to–red and black–to–black).
It is critical that these connections are correct. A harmful arc flash will occur if these connections are crossed.
Figure 11. Install Battery Harness Adapter
12. Slide a heat shrink tubing and center it over the connectors. Use tie-wraps at each end of the heat shrink
tubing to hold it in place (see
WARNING
Figure
12).
Battery Upgrade Instructions for 9355 (20–30 kVA)
Battery Upgrade Procedure
Figure
11). Connect the adapter to the UPS battery
—Rev 01
7
Advertisement
