Esd Protection; Switches; Reset" Button/Momentary Switch; On-Board Dip Switches - abaco systems RTM311 User Manual

UM082 RTM311 User Manual
7.2

ESD Protection

The front panel connectors have ESD protection compliant to IEC 61000-4-2, ±15kV (air), ±8kV
(contact).
7.3

Switches

On-board switches can be identified by the silkscreen.

"RESET" button/momentary switch

7.3.1
"RESET" button (SW1) is made assessible on the front panel, through a small key hole. The VPX
board can be reset by pressing this button.
7.3.2

On-board dip switches

Their functionalities are explained below. All switches are in "ON" position by default, apart from
SW4 which should be "OFF" by default.
Switch
NVRMO = '0'
SW2
SW3 M.2 SATA selected
SW4 JTAG to on-board CPLD
SW5 USB3.0 selected
UM082
Figure 3: RTM311 On-board Connectors locations
"ON"
www.abaco.com
"OFF"
NVRMO = '1'
Standard SATA connector selected
JTAG to VPX backplane (to the connected VPX
payload card)
DisplayPort selected
r1.3
page 8 of 28