Front Panel Connectors - abaco systems RTM311 User Manual

UM082 RTM311 User Manual
7.5.2

Front panel connectors

7.5.2.1 RESET button
See section 7.3.1.
7.5.2.2 DEBUG connector
The system can be debugged using a debug cable which is provided with RTM311.
The debug cable is a customised break-out cable shown below.
Each cable end has its own ID label. The "RTM31x Debug" end is to connect to RTM311 via its
front panel's µHDMI "Debug" connector.
The other ends provide means for debugging with pin assignments shown in the table below.
•
"COM0" via a 9-Way Male D-type connector
Pin VPX signal name
2 FPGA-LVDS1+
3 GND
5 FPGA-LVDS1-
•
"COM1" via a 9-Way Male D-type connector
Pin VPX signal name
2 FPGA-LVDS3+
3 GND
5 FPGA-LVDS3-
UM082 www.abaco.com
r1.3
page 15 of 28