abaco systems RTM311 User Manual page 20

UM082 RTM311 User Manual
QTE connector pin
5/6/11/12/17/18/23/24/29/30/
35/36/45/46/87/88/121/122/123/124/
125/126/127/128/129/130/131/132
Other pins
The QTE connector has pins location shown in the figure below. Odd pins are located on the top
row, starts from Pin1 on the left and ends with Pin119 on the right. Even pins are located on the
bottom row, starts with Pin2 on the left and ends with Pin120 on the right.
1
2
Figure 6: Pin1 and Pin2 location (in yellow) and standoffs location (circled in pink)
Figure 7: SAMTEC mating connector with place for screws circled in pink
To connect to the QTE connector:
•
Use a mating connector from SAMTEC with break out direction towards VPX connectors,
shown as a green arrow in Figure 6. Ensure to check the signals assignment in Table 6
and pins location in Figure 6 above.
•
Place the mating connector on to the on-board QTE connector.
•
Use 2 x 4-40 screws to secure the mating connector to the on-board QTE connector by
inserting the screws on each side of the mating connector (see Figure 6) and tighten them
into the on-board standoffs (approximately 9.45mm stacking height, circled in pink in
Figure 7).
UM082
VPX RP0 signal
GND
Reserved for future development
www.abaco.com
r1.3
page 20 of 28