Table of Contents
Advertisement
Connection and Communication Setup 3
Check Setup:
• Type:
To operate a hard disk digital recorder with
a multiplexer function, this should display
"DVR/MUX".
• Protocol:
When "DVR/MUX" is selected for "Type",
"SANYO DVR/MU" is automatically
displayed.
• Baudrate:
"19200" is automatically displayed. Match
the settings of the connected equipment
(DVR, etc.).
3
Press the
esc
Returns to Communication Setup
selection screen.
4
Press the
"2–TELEMETRY", then press
the
button.
ent
The "2–TELEMETRY" screen is
displayed. Check that the settings are as
shown below.
Check Setup:
• A-Connector:
To operate a camera via video equipment,
this should display "Telemetry".
• A-Protocol:
Match the settings of the connected
camera.
• A-Baudrate:
Match the settings of the connected
camera.
23
Preparation
button.
button, select
ent
esc
ent
5
Press the
esc
Returns to Communication Setup
(COMMUNICATIONS).
6
Press the
Displays Control Setup (ACCEPTED
VALUES) screen.
For "1–CAMERAS" setup, see P47.
7
Press the
"2–MONITOR/LOCAL
DVR-MUX", then press the
ent
button.
Set the connected DVR-MUX.
(P47)
8
This completes the setup.
Proceed to operating the hard
disk digital recorder (P32) or
the camera (P38).
button.
ent
button.
button, select
esc
ent
(Figure 2)
Advertisement
Table of Contents
