Introduction; Receipt Of The Unit; Warranty; Safety Instructions - CIAT condenciat CD Instruction Manual

1 - INTRODUCTION

CONDENCIAT CD units are condensation units. They will be connected to a direct expansion coil.

2 - RECEIPT OF THE UNIT

Each unit has a name plate bearing an identification number. Check the name plate on the unit to make sure you have received
the right model. Please include the identification number in all correspondence with CIAT.
350 to 500
100 to 300 350 to 500
A A
= name plate
A
After unpacking the unit, please inspect it for any damage. If any items are missing or damaged, specify this on the delivery note
and inform the carrier thereof by registered letter within three days of delivery of the unit.
Store at a maximum temperature of 50°C.

3 - WARRANTY

The warranty is effective for a period of 12 months from the date the unit is first commissioned into service provided said date
occurs within three months of the invoice date.
It is effective for a period of 15 months from the unit invoice date in all other cases.
NOTE: refer to our general terms and conditions of sale for further information.

4 - SAFETY INSTRUCTIONS

To avoid any risk of accident during installation, commissioning and adjustments, the following equipment specificities must be
taken into account:
- Pressurised refrigeration circuits
- Presence of refrigerant
- Presence of electrical voltage
Only experienced and qualified persons may work on such equipment.
The recommendations and instructions in this manual and on each drawing provided with the unit must be followed.
In the case of units with pressure equipment or components, we recommend that you contact your professional organisation for
information on regulations that apply to operators or owners of pressure equipment or components. The specifications of this
pressure equipment or these pressure components are given on the name plates or in the regulatory documentation provided
with the product.
A fire protection device is fitted as standard on all units.
IMPORTANT: Make sure the main disconnect switch in the unit's electrical panel is in the OFF position before working on the unit.

5 - UNIT LOCATION

These units are typically used for refrigeration and are not required to withstand earthquakes. Earthquake resistance has therefore
not been checked.
The fitter must check the following points before setting up the unit in its intended location:
- The unit must be installed outdoors
- The surface area of the ground or structure must be strong enough to bear the unit's weight.
- The unit must be perfectly level.
- There must be sufficient clearance around and above the unit to allow servicing and maintenance (see dimensional drawing
provided with unit).
- The room housing the unit must comply with the requirements of regulation EN 378-3 and other specifications applicable to the
installation site.
- The intended location must be above flood level.
NA06.130 C EN - 2