Advertisement
final turn of the spanner. and the unit will be
correctly fitted in position
Petrol Tank.
This is built into a. separate carrier which is
supported on the backstays by two clips Whose
method of assembly is clearly seen at A, Fig. 2,
and by a. special attachment unit which goes above
the backstay bridge.
To attach this it is only
necessary to place the bar B against the rear of
the twin backstay tubes, fit the clip C in the position
shown and insert and tighten up the centre locking
pin D.
In order to place bar B correctly against
the backstay tubes it may be necessary to slacker:
the nuts E slightly, tightening them afterwards.
The operation of fitting the tank is completed
when the petrol pipe between the tap and the
carburetter is attached.
'
See that petrol tank is ievel—or witha slight
downward tilt at rear—when fitted.
Otherwise a
quantity of fuel will remain in the forward end
and prevent a full hall gallon being accommodated
when refilling.
'
On bicycles having a. bent top rail a special
attachment for the tank is necessary to ensure
level fitting; this can be obtained through your
local dealer.
When filling with fuel for the first time see that
there is no airlock in the pipe.
Handlebar Controls.
When the B.S.A. WINGED WHEEL is delivered
the three con trol cabies are already attached to the
unit, and it is therefore only necessary to lead the
cables along the frame tubes and fix them with
the rubber clips provided.
7
Advertisement
