Sanyo POA-MD13NET2 Owner's Manual page 32

Chapter 3 Basic Setting and Operation
When the internal power circuit is failed:
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The Projector lamp was turned off, because projector power circuit failed.
Unplug the projector from AC outlet and ask servicing to qualified service
personnel.
Information: FFFEFFFF
The Projector lamp was turned off, because the projector power circuit failed.
Unplug the projector from AC outlet and ask servicing to a qualified service personnel
with the information code "FFFEFFFF".
When the life span of lamp is reached:
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The life span of lamp is reached.
Replace it with a new lamp immediately and reset the lamp counter. If the projector
is used without reset the lamp counter, the alert mail is sent to users in every power-
on of the projector. This alert mail will not be sent when unchecking the mail sending
condition "When the life span of lamp is reached".
When the lamp use time reaches preselect lamp use time:
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The lamp use time reaches 800 hours. Prepare the lamp replacement.
The Network Board sends a free message when the lamp use time reaches the pre-
selected lamp use time. It can be used for preparation of the lamp replacement and
the maintenance required.
32
Free messages