E-Mail Setting - Sanyo POA-MD13NET2 Owner's Manual

E-mail Setting

This product has an E-mail function which can send an alert message to
users or an administrator if it detects an abnormality on the projector or run
out of the life span of the lamp. Click E-Mail Setting on the main menu and follow the
below steps.
1
SMTP Server*
1
Type the E-mail address of SMTP
server and administrator and click Set
button. The administrator address is
set to "Reply-To" address sent from
the projector.
*1 The SMTP server is a server for send-
ing E-Mail. Please contact your net-
work administrator to have this SMTP
server address.
* If the Network Board sends an alert message due to the abnormality on the projector but
the SMTP server is down in some other reason, the message does not be sent. In this
case, the message "Unable to connect to server." will be displayed on the setting page.
Click Set button to remove the message.
To use the E-Mail function, it must be set the DNS address on the Network setting page correctly.
You cannot use this E-mail function if the DNS server and SMTP server cannot be used in
your network environment. If the SMTP server is located in your LAN (Local Area network),
the address set to SMTP server should be specified the in SMTP server located in your LAN.
The server located outside of your LAN may not be available for security reason. For further
information please contact your network administrator.
Up to 10 E-mail addresses can be registered.
E-mail Setting
Network Board
OWNER'S MANUAL [HD Series]
29