Federal Communication Commission Notice - Sanyo POA-MD13NET2 Owner's Manual

Compliance

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise speci-
fied in the instructions. If such changes or modifications should be made, you could
be required to stop operation of the equipment.
Warning
This is a Class A product. In a domestic environment this product may cause radio
interference in which cause the user may be required to take adequate measures.
- When you receive an alert e-mail from the projector, you must check the projector
immediately. Fire or accident may result if the projector is used in an abnormal
condition.
- When you install the projector at remote location and use it through the network,
you must perform the safety inspections periodically. In this case you must pay
attention to the change of environment in which you installed the projector. It may
cause fire or an accident depending on the change of environment.
We assume no responsibility for the loss or damage of data or damage of the com-
puter caused by use of this product.
2
CAUTION ON USE IN NETWORK
CAUTION