Control The Projector With Telnet - Sanyo POA-MD13NET2 Owner's Manual

Chapter 6 Use of Serial Port

Control the projector with Telnet

This product allows you to control the projector by using the Telnet application.
Normally, it is used to control the external equipment connected to the serial port and
also control the projector itself by specifying the telnet port no.10000.
Specify port no. 10000 as the right on the
serial port setting page. This function
does not depend on other setting items.
In the setting of the computer, specify
the port no. 10000 at the procedure 3 on
the previous setting example page as the
below.
After established the communication, type the
password and the command for controlling the
projector and then enter the "Enter" key.
The right table shows the typical command lists
for controlling our projectors and please consult
your local dealer for further information of anoth-
er commands.
64
Host name : 192.168.0.2
(type a projector IP address)
Port : 10000
Terminal type : vt100
Command
C00
C01
C05
C06
C07
C08
C09
C0A
C0B
C0C
C0D
C0E
C1C
C1D
* Only effective for the 4 slots model.
Command list table
Function
Turn the projector on
Turn the projector off
Selects SLOT1
Selects SLOT2
Selects SLOT3
Selects SLOT4*
Volume up
Volume down
Mute on
Mute off
Video mute on
Video mute off
Menu display on
menu display off