Network Configuration - Sanyo POA-MD13NET2 Owner's Manual

Network board for hd series
Hide thumbs Also See for POA-MD13NET2:
Table of Contents

Advertisement

2
Configuration for IP Address/ Sub net/ Gateway*/DNS*
Press SELECT button again, the following network setting menu appears on the
screen. Enter the specified network address.
3
Restart the Network Board
Select Set with 7 8 keys and press SELECT button again. The network configu-
ration display disappears and the Network Board begins restarting. It takes about
40 seconds. Do not turn off the mains switch during this period.
Completing of installation
Now the installation is completed. The IP address of this projector is set to
"192.168.1.201".
* In the network environments not using a Gateway or Router, the Default Gateway address
should be set to [0.0.0.0]. If you do not use the functions E-mail or DNS server, it is also set
[0.0.0.0] for the DNS address.

Network configuration

How to enter the numbers
There are 2 ways to enter the
numbers, one is by using the
point buttons (d e 7 8) on the
remote control or on the projector,
the other is by using the screen
10-key pallet by which the num-
bers can be entered directory. For
further information see next page.
OWNER'S MANUAL [HD Series]
17
Network Board

Advertisement

Table of Contents
loading

Table of Contents