Notice About System Construction - Sanyo POA-MD13NET2 Owner's Manual

Chapter 2 Installation

Notice about system construction

For installation of multiple projectors into the same network with
Network Board.
Do not install multiple projectors with Network Boards that have their default net-
work settings to the same network. The use of the Network Boards which have the
default IP address set to the same network settings will cause IP addresses to collide
and create a malfunction. When you install multiple projectors into the same net-
work, configure the network with the following steps.
1. Change the IP address from the default IP address. To change the IP address, use
the network setting menu on the projector. Please see item "Network
Configuration" for further information (
2. Make sure that there is no network equipment set with the same IP address in the
network before connecting to the network.
3. When installing other projectors, follow the above steps to change the IP address
and connect to the network.
In case of installing the projector with Network Board into the network
constructed with the DHCP/BOOTP server.
This Network Board does not support the DHCP/BOOTP server. The static IP address
must be manually configured. To use this product in this network environment, set it
up so that the DHCP/BOOTP server does not assign the IP address configured to this
product for another device on the network. Please consult your network administra-
tor for further information.
20
p.16).