Connection Of Lan Cable - Sanyo PJ-Net Organizer Plus POA-PN40 Owner's Manual

Connection of LAN cable

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair)
straight cable with RJ-45 plug. There are two different types of cables depending on
whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub
(10Base-T or 100Base-TX) to distribute the network cable if required.
1
Disconnect the AC plug from the
projector.
2
Connect the UTP straight cable to the
LAN port on the Network Unit.
3
Connect the UTP straight cable to the hub.
Projector
✐ Use the UTP cross cable when you connect the computer and projector directly not using the
hub.
✐ When you connect the projector into the 10Base-T network, use cable with category 3 or 5.
When you connect the projector into the 100Base-TX network, use cable with category 5.
✐ The length of cable between hub and projector should be less than 100m.
Installation and network configuration
Hub
(10Base-T, 100Base-TX)
UTP straight cable
17
PJ-NET ORGANIZER
OWNER'S MANUAL