Control The Projector With Telnet - Sanyo PJ-Net Organizer Plus POA-PN40 Owner's Manual

Chapter 5 Use of Serial Port

Control the projector with telnet

This product allows you to control the projector by using the telnet application.
Normally, it is used for controlling the external equipment connected to the serial
port but it also controls the projector by specifying the telnet port number 10000.
* To control the projector with telnet application is not depending on the serial port set-
ting.
In the step 2 of the previous page, enter port number "10000" after the IP address number.
> open 192.168.1.201 10000 [return]
After the communication is established, type the password (PIN code) and the com-
mand for controlling the projector and then press "Enter" key.
The table below shows the typical command lists for controlling the our projector
and please consult your local dealer for further information of another commands.
68
* Use the IP address
assigned to the pro-
jector
Command list table
Command Function
C00 Power on
C02 Power off
C05 Selects input1
C06 Selects input2
C07 Selects input3
C09 Volume up
C0A Volume down
C0B Audio Mute on
C0C Audio Mute off
C0F Screen Normal size
C10 Screen Full size
C1C Menu display on
C1D menu display off
C23 Input2 (Video)
C24 Input2 (Y,Pb/Cb,Pr/Cr)
C25 Input2 (RGB)
C33 Input3 (Video)
C34 Input3 (S-Video)
C35 Input3 (Y,Pb/Cb,Pr/Cr)