Daikin RZQ Series FCQ20EVA Service Manual page 23

SiME281501E
DISPLAY "
TRANSMISSION)
1
This lights up when a signal is being
transmitted.
DISPLAY "
" " (OPERATION MODE)
2
This display shows the current
OPERATION MODE. For cooling only type,
" " (Auto) and "
installed.
H
DISPLAY "
3
This display shows the set temperature.
DISPLAY "
hr.
(PROGRAMMED TIME)
4
This display shows PROGRAMMED TIME
of the system start or stop.
5
DISPLAY "
DISPLAY "
6
The display shows the set fan speed.
DISPLAY "
(INSPECTION/TEST OPERATION)
7
When the INSPECTION/TEST
OPERATION BUTTON is pressed, the
display shows the system mode is in.
ON/OFF BUTTON
Press the button and the system will start.
8
Press the button again and the system will
stop.
FAN SPEED CONTROL BUTTON
9
Press this button to select the fan speed,
HIGH or LOW, of your choice.
TEMPERATURE SETTING BUTTON
Use this button for SETTING
10
TEMPERATURE (Operates with the front
cover of the remote controller closed.)
PROGRAMMING TIMER BUTTON
Use this button for programming
11
and/or STOP" time. (Operates with the
front cover of the remote controller
opened.)
12 TIMER MODE START/STOP BUTTON
13 TIMER RESERVE/CANCEL BUTTON
Remote Controller
" (SIGNAL
" " " " " " "
" (Heating) are not
M L
" (SET TEMPERATURE)
C
"
hr.
" (AIRFLOW FLAP)
" " " (FAN SPEED)
TEST "
"START
AIRFLOW DIRECTION ADJUST BUTTON
14
OPERATION MODE SELECTOR BUTTON
15
Press this button to select OPERATION
MODE.
FILTER SIGN RESET BUTTON
Refer to the section of MAINTENANCE in
16
the operation manual attached to the
indoor unit.
INSPECTION/TEST OPERATION BUTTON
17
This button is used only by qualified service
persons for maintenance purposes.
EMERGENCY OPERATION SWITCH
18
This switch is readily used if the remote
controller does not work.
RECEIVER
This receives the signals from the remote
19
controller.
OPERATING INDICATOR LAMP (Red)
This lamp stays lit while the air
20
conditioner runs. It blinks when the unit
is in trouble.
TIMER INDICATOR LAMP (Green)
21
This lamp stays lit while the timer is set.
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
22
Lights up when it is time to clean the air
filter.
DEFROST LAMP (Orange)
Lights up when the defrosting operation
23
has started. (For cooling only type this
lamp does not turn ON.)
NOTES
• For the sake of explanation, all indications
are shown on the display in Figure 1 contrary
to actual running situations.
•
Fig. 1-2 shows the remote controller with the
front cover opened.
•
If the air filter cleaning time indicator lamp
lights up, clean the air filter as explained in
the operation manual provided with the
indoor unit.
After cleaning and reinstalling the air filter
press the filter sign reset button on the
remote controller. The air filter cleaning time
indicator lamp on the receiver will go out.
•
The Defrost Lamp will blink when power is
turned ON. This is not an error.
Wireless Remote Controller
C: 3P107422-11J
14