Configuring Rs232 Command - Nexcom PowerDigis V2 User Manual

Chapter 4: Advanced settings for player

4.6.2 Configuring RS232 Command

Follow below steps to configure RS232 command:
Step1.Click RS232 Command
Step2. Enter the name of RS232 command
Step3. Enter the command
Step4. From the COM Port dropdown menu, select the COM port to be
used.
Step5. From the Baud Rate dropdown menu, select the baud rate to be
used.
Step6. From the Data Bits dropdown menu, select the data bits to be
used.
Step7. From the Parity Control dropdown menu, select the parity
control type to be used.
Step8. From the Stop Bits dropdown menu, select the stop bits to be
used.
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
Step9. Click Save.
Step10. After you complete all the required setting for RS232 command
configuration, click TEST to verify if the RS232 command configuration
works.
31
PowerDigis V2 Player User Manual