Dometic 3314080.000 BLACK Operating Instructions Manual page 4

ABOUT YOUR NEW THERMOSTAT
Once the system is completely installed, do a system reset:
1. Make sure the CCC 2 thermostat is in the OFF mode. See section, "C. Quick
Reference To Control Buttons" on page (5).
2. Simultaneously press and hold the MODE and ZONE buttons. See section, "C.
Quick Reference To Control Buttons" on page (5).
3. The LCD will display "IniT" and all available zones.
4. Release the MODE and ZONE buttons.
5. Press the ON/OFF button to exit system set up.
6. The furnace ON/OFF temperature differential should be set at this time. For
further information on furnace mode differential setting, see section, "F. "FURN"
/ "AQUA" - Furnace Or Aqua (Hydronic) Heating Mode" on page (11).
Any time a system reset occurs, the factory default settings are restored. See table,
"Factory Preset Settings" on page (4).
In the unlikely event of CCC 2 system memory loss or dip switch setting change, the
CCC 2 thermostat will require a system reset. For system reset procedure, see main
heading, "System Reset Procedure" on page (19).
Your Dometic CCC 2 thermostat has been pre-programmed. Review settings below
and adjust the settings to your personal comfort level.
Any time the CCC 2 is in an idle stage (not illuminated) you will need to wake it
up by pressing any button on the CCC 2 before it will recognize a new setting
attempt.
Factory Preset Settings
Function
Time of Day (Clock)
Heating
Cooling
Automatic
Fan Speed
Mode
All Zones
Each Zone
68 °F / 20 °C
72 °F / 22 °C
70 °F / 21 °C
Factory Preset Settings Each Zone
Setting
— — —
Auto
Off
4
Program "1"
Function
Heating
Cooling
Automatic
Fan Speed
Mode
Time
Program "2"
Heating
Cooling
Automatic
Fan Speed
Mode
Time
Setting
68 °F / 20 °C
72 °F / 22 °C
70 °F / 21 °C
Auto
Off
8:00 AM
68 °F / 20 °C
72 °F / 22 °C
70 °F / 21 °C
Auto
Off
10:00 PM