Document Symbols; About Your New Thermostat; Features; System Configuration & Initialization - Dometic 3314080.000 BLACK Operating Instructions Manual

TABLE OF CONTENTS
A. Reduce Heat Gain ................................................................................................................... 19
B. Disclaimer ................................................................................................................................ 19
MAINTENANCE ..........................................................................................................................................20
A. Air Filter ...................................................................................................................................20
B. Dometic CCC 2 Thermostat .................................................................................................... 20
SERVICE .....................................................................................................................................................20

DOCUMENT SYMBOLS

Indicates additional information that is not related to personal injury.
Indicates step-by-step instructions.

ABOUT YOUR NEW THERMOSTAT

A. Features
● Liquid Crystal Display
● Two operation programs
● Constant time of day display
● Remote Sensor (Precise comfort control within 1 °F of set-point)
● Display reminder lets you know when to service or replace filters
● Up to four independent zones
To help familiarize yourself with the operation of the CCC 2 thermostat, review the
following diagrams and accompanying text that explain the functional characteris-
tics of this system.
Your CCC 2 thermostat is equipped with a liquid crystal display (LCD) that identifies
the mode of operation (OFF, Cool, Heat Pump, Fan, Heat Strip, Auto, & Furnace
or Aqua), temperature set-point, zone identification ("1", "2", "3", "4"), fan speed
("Auto," "Low," "Med," "High"), program "1" and "2", inside temperature, clock,
°F / °C, compressor delay, and filter maintenance. The modes of operation viewed
in the LCD will vary depending on the system installed in your RV.
B. System Configuration & Initialization
The installer of your system will set the required system DIP switches to the ON
position. In order for the CCC 2 thermostat to recognize the system zones, type of
units installed and their options, a system reset must be done.
3