Advertisement
7.2. Teaching in on MAX! components
(without a MAX! cube)
You can also teach the MAX! window sensor in on other
MAX! components (without a MAX! cube).
• Start by switching the teach-in partner (e.g. the MAX!
wall thermostat) to teach-in mode.
• To activate teach-in mode on the MAX! window sensor,
press and hold down the teach-in button on the electro-
nic unit (see page 22). The device LED starts to flash.
• Successful teaching in of the MAX! window sensor is
confirmed by the LED lighting up once.
• Finally, place the cap on the electronic unit.
To initialise the window sensor, open and close the
window to which the MAX! window sensor is moun-
ted once.
The wireless window sensor can only be taught in
on a maximum of one MAX! cube or one MAX! wall
thermostat.
The MAX! window sensor can be reset to the initial state
manually. Restoring the initial state deletes all settings and
information about taught-in devices.
• First remove the batteries from the electronic unit.
• Wait 60 seconds.
• Hold down the teach-in button and at the same time re-
insert the batteries.
• Press and hold down the teach-in button until the LED
8. Teach-out/Reset
23
Advertisement
Chapters
