10 Maintenance
10.2
Checking operation of the appliance
Fig.95
Fig.96
10.3
Specific maintenance operations
1
2
Fig.97
1
90
iHPI
This function is used to force the heat pump and back-up in heating or
cooling mode, in order to check that they are working correctly.
MW-5000132-5
MW-5000750-1
10.3.1
10.3.2
Clean the filters during the annual service.
2
MW-6000360-1
1. Access the Test menu by pressing the two keys on the left
simultaneously.
XX represents the flow temperature
2. Switch from C:XX heating to R:XX cooling mode using the
keys.
3. Exit the Test menu and go back to the main display by pressing the
key.
Draining the heating circuit
1. Connect a hose (internal diameter: 8 mm) to the drain valve on the
heating circuit.
2. Open the drain valve.
3. Await the complete drainage of the heating circuit.
Cleaning the 500-µm filter
1. Close the filter valve.
2. Unscrew the cover (24-mm spanner).
and
7701563 - v02 - 22052018