Siemens SINAMICS IOP-2 Operating Instructions Manual page 39

Select On: Hand/Auto from
PLC or DI
Select input to receive control
signal
The HAND/AUTO button is now disabled and local control of the IOP-2 cannot be activated
by the HAND/AUTO button. In this example, the converter is now setup to receive the
HAND/AUTO command from Digital Input 1 (DI1).
Note
Power-cycle required to complete the HAND/AUTO disable function
When the HAND/AUTO disable function is initiated the function will not become active until a
power-cycle of the IOP-2 has been performed. When the HAND/AUTO disable function is
turned off, again, a power-cycle of the IOP-2 is required to complete the deactivation of the
function.
Intelligent Operating Panel 2 (IOP-2)
Operating Instructions, 04/2017, FW V2.0, A5E39549448B AA
Enter password again or
create a new password
Press ESC to return to
Control Menu
Control menu
6.6 HAND/AUTO disable
Select signal source
39