Siemens SINAMICS IOP-2 Operating Instructions Manual page 56

Menu
7.6 Extras Menu
the actual screens may vary depending on the type and firmware of the converter that is
being used.
Changing pre-assigned input and output settings
Some inputs and outputs may already be assigned a function, it is recommended that these
assignments are not changed, unless it is required for a particular type of application.
If the pre-assigned inputs/outputs are changed, it is essential that the application is
checked to ensure it will function correctly and as expected.
Removal of the ON/OFF command
If removing the ON/OFF command from a digital input (p0840), the indices will be changed
to 1, thereby resetting this parameter.
This will make the ON/OFF function of the converter not operate correctly, or as anticipated
by the user.
Please ensure that during the commissioning of the converter the ON/OFF command
functions properly and as expected for your specific application.
Editing the inputs and outputs
Select Menu
Select I/O to be configured
When the final selections have been made, press ESC twice to return to the I/O Editor
screen to configure another input or output or a long press of ESC to return to the general
status screen.
56
CAUTION
CAUTION
Select Extras
Set the actual I/O
Operating Instructions, 04/2017, FW V2.0, A5E39549448B AA
Select I/O Editor
Select the function of the I/O
Intelligent Operating Panel 2 (IOP-2)