Shutting Down The Cooling Function; Frost Protection - Baxi Platinum BC iPlus Installation And Service Manual

Reversible air/water "split inverter" heat pump

Table of Contents

9 Operation

Fig.99

MW-5000027-4

Fig.100

Fig.101

9.4

Frost Protection

AWHP-2 iMPI

1. Go to stop mode by pressing the

2. Select the heating mode by pressing the

3. Confirm by pressing the

MW-5000133-3

4. Select the heating shut-down pressing the

5. Confirm by pressing the

MW-5000134-3

6. Go back to the main display by pressing the

9.3.2

1. Access the

2. Confirm access by pressing the

3. Select CIRCA or CIRCB by pressing the

4. Confirm the selection by pressing the

5. Select TP.C by pressing the

6. Confirm the selection by pressing the

7. Modify the timer program to stop cooling.

If the temperature of the heating water in the heat pump falls too much,

the integrated protection device switches itself on. This device functions as

follows:

If the water temperature is lower than 5°C, the circulating pump starts

up.

If the water temperature is lower than 3°C, the back-up starts up.

If the water temperature is higher than 10°C, the back-up shuts down

and the circulating pump continues to run for a short time.

The screen displays:

The frost protection function continues to run.

The heating and cooling have been shut down.

Important

Press the

key to restart the appliance: the screen will

display

Important

The display disappears after a few seconds of inactivity.