Safety System Tests - Challenge MS-5 Instructions And Parts Manual

Paper drilling machine

Hide thumbs Also See for MS-5:

Table of Contents

Machine manufacturer _______________ Model ____________

Serial Number __________________

Frequency of test: THESE TESTS SHOULD BE PERFORMED AT THE BEGINNING OF EACH WORK DAY.

Connect power to the machine, turn the main disconnect switch to the "on" position, and press the "on" button.

Check both motors to see that they are operating.

Test #1:With the machine running, open the upper front cover. This should stop all motion. Close front cover.

Test #2:With the machine running, remove the front guard. This should stop all motion. Replace guard.

If the motors continue to run during either test, readjustment or repair is needed.

Please enter date and initials for both tests.

Date

______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Date

______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Date

______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 1 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Test 2 ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______ ______

Repairs

_________________________________________

F.300-B/MS-5 DRILL/JULY 2000