Table of Contents
Advertisement
Settings
To use the functions of this unit effectively, the recording conditions and installation environment must
be specified beforehand. These setting items are arranged and displayed in two levels consisting of the
main menu and sub-menus.
Refer to the setting procedures for each menu on the following pages for details on the various setting
methods.
I I I I Menu Selection Method
1
Click the R button on the operating panel to
display the [MAIN MENU] screen.
2
When the specified menu on the [MAIN MENU]
screen is selected and clicked, the sub-menu will
be displayed.
3
Change the required settings from the sub-menu
screen.
4
To clear the menu screen, click the Playback mode
P button on the operating panel to leave the
menu screen and display the live screen.
I I I I Menu Configuration
Recording
1. CLOCK SET
conditions
2. DAYLIGHT SAVING/EXT. CLOCK SET • DAYLIGHT SAVING • EXT. CLOCK SET
3. PROGRAM REC SET
4. RECORDING AREA SET
5. RECORDING CONDITIONS SET
6. NORMAL REC MODE SET
7. TIMER SET
8. HOLIDAY SET
9. ALARM REC MODE SET
10. ALARM DURATION SET
Installation
11. DISPLAY SET
environment
12. RS-232C/RS-485 SET
13. BUZZER SET
14. NETWORK SET
15. HDD SET
16. POWER FAILURE/USED TIME
*
Shaded items are for information display only.
English
Main menu
• TOTAL CAPACITY • RECORDING AREA CAPACITY
• AREA FULL RESET
• NORMAL RECORDING AREA OVERWRITE
• ALARM RECORDING AREA OVERWRIGHT
• REMAINING DISK WARNING
• PICTURE QUALITY • AUDIO RECORDING
• REC RATE • REC PROGRAM GROUP
• PICTURE QUALITY • AUDIO RECORDING
• ALARM RECORDING (REC MODE, PROGRAM GROUP, REC
RATE, DURATION)
• PRE-ALARM RECORDING (REC RATE, DURATION)
• ALARM TRIGGER
• DATE • TIME • QUALITY • REC RATE
• ALARM COUNT • ALARM TYPE
• CONTROL • DATE SPEED • STATUS INFO
• ALARM INFO • ADDRESS
• ALARM • DISK FULL • DISK ERROR
• LOCK WARNING • KEY IN • NON REC
• IP ADDRESS • SUBNET MASK • GATE WAY • PORT
• PASSWORD SETTING • NETWORK SPEED
• DISK CAPACITY • MIRRORING
• PLAYBACK DRIVE
• POWER FAILURE • USED TIME • FIRMWARE
• Because entry from playback mode is not
possible, click the stop button to return
temporarily to live mode and then click the R
button.
• You must be connected at the ID3 user level in
order to change settings.
• If the main unit is recording, the menu details can
be checked but the settings cannot be changed.
• When moving from one sub-menu to another sub-
menu, first click the R button to return to the
main menu.
Sub-menu
7
Reference
page
8
8
9
10
11
12 to 13
14
15
15 to 17
18
18
19
19
20
21
21
Advertisement
Table of Contents
