Work Orders And Job Codes - Graco Matrix 5 Instructions Manual

Setup

Work Orders and Job Codes

Refer to the Matrix 3 Software manual for instructions on
creating and sending Work Orders and Job Codes using
the PC and/or Global Work Orders.
The System Administrator can program the meter to
process work orders using one of the following methods:
• Work Order/Job Code at the PC only
• Work Order/Job Code at the PC and Meter
Work Orders can have a maximum of (8) characters.
The Job Code can have a maximum of (3) characters.
The Work Order number is separated from the Job
Code with a dash (-) (F
IG
ENTER W.O
1 2 3
W E B
CANCEL
F . 24
IG
The numbers, 0 - 9; alphabet characters, A - Z; and
period (.), forward slash (/) and dash (-) or space
characters can be used when assigning a Work Order or
Job Number. One Work Order can require more than
one service.
NOTE: One naming convention that can be
implemented for identifying different services on a Work
Order is adding an extension to the end of the order
number (i.e., 123456.oil, 123456.atf).
On meters configured to enter Work Orders and Job
Codes at the PC only, the screen shown in F
displays before the Dispense Screen.
The meter can receive any number of work orders. New
work orders added at the PC will appear at the end of
the work order list.
18
. 24).
4 5 6 7 8
ENTER
ti12271a
. 25
IG
On the meter, use the UP or DOWN ARROWS to scroll
through the list of entered work orders.
MOBIL1 5W-20
SELECT
ti12404a
F . 25
IG
On meters configured to enter Work Orders and Job
Codes at the PC and meter, the screen shown in F
displays before the Dispense Screen.
Work orders entered at the meter appear at the
beginning of the Work Order list on the meter and are
placed ahead of Work Orders previously entered on the
PC.
MOBIL1 5W-20
SELECT
ti12270a
F . 26
IG
. 26
IG
ENTER NEW
313046T