Change The Default Login - Honeywell IF2 User Manual

Change the Default Login

If you are not using a password server to authorize user logins, Honeywell recom-
mends that you change the default user name and password and create a read-
only password.
1. From the main menu, click Security > Passwords. The Passwords screen
2. Make sure the Enable RADIUS check box is not checked. Clear this check box if
3. Configure the parameters. For help, see the next table.
4. Click Activate Changes to save your changes and immediately make them
Password Parameter Descriptions
Parameter
Username
Password
Read-only Password
20
appears.
necessary and then click Activate Changes.
active.
Description
Enter the user name you need to use to log in to this IF2. The user name
can be from 1 to 32 characters long. You must always specify a user
name. Default is intermec.
Enter the password you need to use to log in to this IF2. This password
gives you read and write access to the IF2 configuration. The password
can be from 8 to 32 characters long. You must always specify a password.
Default is intermec.
Enter the password you need to use to log in to this IF2. This password
gives the user read-only access to the IF2. This user can view the
configuration and execute diagnostics but cannot perform any tasks that
affect IF2 operation, such as changing configuration options or
upgrading firmware. Default is readonly.
The read-only password cannot be deleted. To disallow read-only access,
you need to enable RADIUS authentication. For help, see
Security" on page 16.
IF2 Network Reader User Guide
"Configure