Relay Outputs; Analog/Digital Inputs; Digital Outputs - Eaton RI-2 Installation Manual

Relay Outputs

There are 8 Relay Outputs that can be wired to
provide low voltage or line voltage outputs.
• Normally open and Normally closed
terminals available for each relay
• Low voltage volt free outputs
• Line voltage rated at 3 Amps AC for
general use, resistive, incandescent
lamps (tungsten), electric discharge
(ballast) loads and ¼ HP AC motor loads
for use at 120 and 240 VAC.
• Do not mix low voltage and line voltage
on relay output terminals
• Controlled as channels 1-8
Connections are made via two 12-way 2 part
connectors with screw terminals.
Wire Gauge for Relay Outputs: Terminals
suitable for wire sizes from 24AWG (0.25mm2)
to 12AWG (4mm2).
The unit is supplied with knockouts, suitable
for 3/4" (19mm) cable glands, for relay output
wiring. An appropriate cable gland should
be fitted to each knockout hole to protect the
cabling from damage.

Analog/Digital Inputs

The unit has eight inputs which can be
configured via software for either digital or
analog input signals.
• Individually programmable to be analog or
switch inputs
• Analog inputs accept 0 – 10VDC signals
Note: Wire distance from the device to the
RI-2 should not exceed 32 feet (10m).
Connections are made via a 9-way two part
connector with screw terminals.
The unit is supplied with knockouts, suitable
for 3/4" (19mm) cable glands, for analog/digital
input cabling. An appropriate cable gland
should be fitted to the knockout hole to protect
the cabling from damage.
Wire Gauge for inputs: terminals suitable for
wire sizes from 24AWG (0.25mm2) to 12AWG
(4mm2).
Eaton - Lighting Systems

Digital Outputs

The unit has eight digital outputs. These can be
configured as:
• LED drive indicators of switched output
status
• Digital control channels
• Controlled as channels 9-16
Connections are made via the 9-way two part
connector with screw terminals.
Wire Gauge for Digital outputs: terminals
suitable for wire sizes from 24 AWG
(0.25mm2) to 12 AWG (4mm2).
The unit is supplied with knockouts, suitable
for 3/4" (19mm) cable glands, for digital output
wiring. An appropriate cable gland should
be fitted to the knockout hole to protect the
cabling from damage.
iLight Product Series - RI-2 73-897-00 IM8791 Iss 5 7