Table of Contents
Advertisement
Compact USB Duplicator controller user manual
DO NOT unplug USB drive from the duplicator during the execution process of a task. It
5.
may cause damage to the duplicator system and media.
It is strongly recommended that the capacities of the source and target media are equal
6.
or similar.
It is not recommended to use USB card reader to copy different media on the USB
7.
duplicator, such as CF/SD/MS cards. It may cause damage to the duplicator system and
media.
DO NOT plug in USB or flash media until the duplicator boots up. It may cause abnormal
8.
results if a USB or flash media with quality issue is plugged in before or during the boot
up process.
III. Synchronous /Asynchronous Mode
1. Synchronous Mode
Synchronous Mode (default)
source and target devices have been inserted and the ENT button is pressed. The task will
begin and end at the same time for all target devices. Any other target device plugged in during
the process of a task will not be executed with the task. Go to section 6.2 Asynchronous
Mode to enable or disable this function.
a.
Insert source media into the source channel and blank media into the target channels
properly. The LCD display will show no source disk when source media is not plugged
in yet, and show the number of target media inserted when source media plugged in.
b.
The green LED will be on if the target device is plugged in properly.
c.
Select the task from menu, and press ENT button to execute it.
d.
During the execution process, the status of each target device can be checked by
using the ▲ and ▼ buttons.
e.
After the task is done, LCD display will show the number of successful and failed target(s),
and execution time. Go to section 6.10 Show Result Time to set up the display of time.
2. Asynchronous Mode
Asynchronous Mode means that the duplicator will read the data from source device into
means that the duplicator will start to execute a task after the
Page 6 of 17
Advertisement
Table of Contents
