Advertisement
MEMORY HANDSET
MANUAL
Wake:
To wake press any button.
Calibrate
PRESS/HOLD
or Reset:
GLP:
stands for Go to Lowest Position. This means your desk must be re-calibrated.
CON:
stands for Connection. One of the frame legs are not working properly. Unplug the device and plug it back in.
stands for HIT. This protects your desk against collisions that could lead to damage.
HIT:
if something hits your frame while it is raising or lowering, it will automatically stop and Memory Handset will read
OH:
stands for Overheat. This will show up if the desk has had two minutes of constant usage. To resolve, wait 15 minutes for
your desk to cool down.
OLU:
stands for Overload, this means there is too much weight on your frame. Either remove some weight or change the load
capacity on your frame in setting
Set
ADJUST to 1st preferred height
Preferred
PRESS
Heights:
15 seconds
LED Display shows
PRESS
REPEAT steps for remaining settings.
Setting One
Menu
Setting Two
Setting Three
HOLD until Display shows
Up Arrow
LED Display
Down Arrow
RELEASE then Display shows 60.
Advertisement
