Wiring; Opening And Closing; Dimensions And Mounting5 - BEA FALCON User Manual

WIRING

US Wire Color: Red
12-24 VAC/DC
European Wire Color: Brown Green
Opening the sensor
OPENING AND
CLOSING THE
SENSOR
• Loosen the retaining nut
• Partially unscrew the 2 front cover
• Pull out the front cover with the 2
SENSOR
DIMENSIONS
AND
MOUNTING
Remark: The bold-type values give the minimum distance required to be able to fully adjust the sensor.
BRACKET
MOUNTING
75.5351.02 EN 20080317 (75.5350)
Black White Green Yellow
COM NO
White Yellow
until the cable slides easily into the
grommet;
screws;
front cover screws.
Ceiling Mounting
2.5 in
5 in
6.25 in
NC
Gray
Closing the sensor
• Connect the quick disconnect terminal block to the main
electronic circuit;
• Slide the main electronic circuit into the 2 housing slot
guides;
• Gently push the front cover and make sure that the external
housing is properly seated (front cover must be flush with
housing).
• Screw the 2 front cover screws and tighten the retaining nut.
To remove or to
insert the cable:
• Unscrew the retaining
nut;
• Pass the cable through
the grommet and the
retaining nut.
• Tighten the retaining nut.
Wall Mounting
5 in
6.25 in
• Check that both locking collar
are at the same angle;
• Align the bracket slot to the
locking collar guide as shown.
Page 2 of 7