Snap Disc Replacement - Heatilator ECO CHOICE WS18-AU Owner's Manual

Heatilator EcoChoice WS18
E. Snap Disc Replacement
1. Disconnect power supply. Locate the snap disc bracket
assembly at the bottom left rear corner of the appliance
(Figure 24.1).
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the
snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 24.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc Location
Figure 24.1
Snap Disc
Magnet
Figure 24.2
24
Spade
Connectors
7056-153F • 20 August, 2018
www.heatilator.com