Engine Set Speed - Kubota WG752 E3 Applications Manual

[Other Check Items]
You must confirm that the fuel parts layout is consistent with what was tested at the application review.
Please confirm the following items.
• Installation of heat cover, fuel hose, etc.
• The temperature of the fuel in the fuel tank must be less than temperature to prevent fuel boiling at all operating
conditions.
• If you use a carbon canister, the capacity of fuel tank and the carbon canister is confirmed.
• The liquid gasoline does not enter from the fuel tank to the evaporative canister at all operating conditions.
(at inclination, volume expansion by heat, surface level difference by vibration and etc).
NOTE
• It is equipment manufacturer's responsibility to make sure the fuel system will comply with the applicable
evaporative emissions regulation.
• It is equipment manufacturer's responsibility to test and confirm the evaporative system will not cause
engine performance issues at any operating condition.

[5] Engine Set Speed

[Mechanical Governor specification]
• You should operate the engine within the engine speed range set at the time of Kubota shipment
(without parasitic load).
• You should use the speed control lever and/or the governor lever to change engine speed.
[Electronic Governor specification]
• If you use the electronic governor, consult KUBOTA before the application review.
10