Wiring Diagram - Polaris NG60 User Manual

Wiring Diagram

Plugs into back of monitor
Wiring Notes:
• The NG60 has 4 camera inputs but is designed for one camera to be triggered when
reverse gear is engaged.
• Whichever camera you want to trigger when reverse gear is engaged, please make
sure you plug it into the reverse camera input.
• You can still access Cam 1, 2 & 3 whilst in reverse, please see page 4 for instructions
on how to do this.
• If you don't wish for a camera to activate whilst in reverse, then simply plug your
camera into either Cam 1, 2 or 3 as you can view these cameras whilst driving.
• Cam 1, 2 & 3 can be accessed at any time whilst driving forward, please see
page 5 for instructions on how to do this.
• The NG60 is 12-32Volt and is built into the monitor.
• If you are only wiring up one camera to engage when in reverse please run the
Acc+ (red) along with the reverse trigger wire (green) directly to your reverse lights.
This way the monitor will power down when drive is activated. If you add an
additional camera(s) at a later stage, please run the ACC+(red) to accessories
power so you can access the additional camera(s) whilst driving.
If you have any questions in regards to the wiring of this unit, please contact
Polaris on 1300 555 514
3
Reverse Camera
Cam 1
Cam 2
Cam 3
Reverse (Green)
GND (Black)
Acc+ (Red)