Blade Attachment - Regency Artiste Owner's Manual

F
INISHING THE
1. Tuck connections neatly into ceiling outlet box.
2. Remove one of the hanger bracket screws from the bottom of the
hanger bracket and loosen the other screw a half turn from the
screw head.
3. Slide the canopy up to the hanger bracket and place the key hole
on the canopy over the loose hanger bracket screw on the hanger
bracket. Turn the canopy clockwise until it locks in place at the
narrow section of the key holes.
4. Align the circular hole on the canopy with the remaining hole on
the hanger bracket. Secure the hanger bracket screw previously
removed into the hole, and tighten the two hanger bracket screws.
5. Attach the canopy screw cover plate to the hanger bracket screw
heads on the bottom of the canopy by inserting the screw heads
into the key slots in the canopy screw cover plate and rotating the
canopy screw cover plate clockwise.
WARNING: WARNING: Make sure the hook on the hanging bracket properly sits
in the groove in the downrod ball before attaching the canopy to the
bracket by turning the housing until it drops into place.
B A
LADE TTACHMENT
Fasten blade to motor with provided flat washers, lock washers and blade mounting screws. Repeat procedure for
remaining blades. Make sure screws are TIGHT! Loose motor screws can contribute to unnecessary hum during
operation.
NOTE: NOTE: Cordless power screwdrivers are NOT
will not fully compress the lock washers on the motor screws. Use a large flat blade screwdriver for final tightening to
fully compress the washers. This will help ensure proper alignment of the blades and noise-free, wobble-free running.
I
NSTALLATION
NOT recommended, as they tend to strip the heads of the screws and usually
I
NSTALLING THE
Flat washers
Lock washers
7
F
AN
Ceiling Fan
Outlet Box
Hanger
Bracket
Canopy
Canopy Screw
Cover Plate
Blades
Screws
Screws