Table of Contents
Advertisement
Racewell HD
USING THE CRUSH - DASH CONTROLS
Racewell HD
There are several operating options on this unit Starting from the right on the dash
HOLD PRESSURE KNOB
direction increases the pressure up to a maximum pressure This knob can be used to
regulate pressure for small lambs through to large rams
HOLD SWITCH
To activate this switch, move switch to the upward position This catches the
sheep on activation To release the switch, move to the downward direction
This is a master switch and will over ride any mode
TILT OPTION / FOOT PEDALS
Twin operated foot pedals are supplied with an electric 12v lead and plug
This connects to the plug found on the operating side of the unit The left
pedal tilts the unit up, and the right pedal lets it down If something goes
wrong, removing your foot off the pedals will stop all movement In the event of power
failure or no air, an emergency valve is used on the back side under the unit
DRAFT SWITCH
As on the panel, moving the switch to the left, drafts to the left, in the
centre is straight ahead, and to the right drafts to the right When using in
autodraft mode, the switch must be left in the centre However, this switch
can also be used to override autodraft at any time Remember to place it back to the
centre before continuing
Te Pari - www.tepari.com - FREEPHONE 0800 837 274
www.tepari.com
NZ 0800 837 274
Turning the knob anti clockwise as far as it will go, will operate
the crush wall with very little pressure, too little to hold a sheep
This is a test mode only Turning the knob in a clockwise
9
SHEEP HANDLING SYSTEMS
HD3 Sheep Handler Installation Manual
1214-V1
Hide quick links:
Advertisement
Table of Contents
