Te Pari Racewell HD3 Installation And Operation Manual page 25

Racewell HD
SYMPTOM Eyes are not working
Possible causes
Faulty eye switch
Dirty or broken eye
Eye cables broken or frayed
SYMPTOM The indicator displays ------------
Possible causes
There is a problem with the loadbars
SYMPTOM Indicator readout is fluctuating or not zeroing
Possible causes
Plugs not completely connected
Plugs are damp
Battery is not adequately charged
Unit is damp
Electrical interference
SYMPTOM Not automatically drafting or releasing
Possible causes
Comms cable fault
Incorrect indicator settings
SYMPTOM Tru-Test indicator displays "Wait for Trigger"
Possible causes
Dirty eyes
Faulty "Y" or Comms cable
SYMPTOM Indicator not zeroing
Possible causes
Tension in loadbars
Te Pari - www.tepari.com - FREEPHONE 0800 837 274
SHEEP HANDLING SYSTEMS
Possible solutions
Replace
Clean and re-check, replace if required
Replace cable from autobox to eyes
Possible solutions
Contact the manufacturer
Possible solutions
Check the plug that goes over the loadbar collar is not
preventing the pins from engaging properly
Check loadbar cables are firmly in place, don't over tighten
Check for moisture - clean with methylated spirits
Ensure dust caps are screwed together
Check battery charge state
Check indicator to unit cord
Electrical interference from a short on a electric fence can
affect your indicator
Battery and unit charges must be kept dry
Possible solutions
Communication cable from indicator to unit is damaged
or has dirty terminals - clean terminals with CRC
Communications cable is in the wrong port (Tru-Test)
Check your indicator settings are correct
Possible solutions
Clean eyes
Check the "Y" and Communications cables and the cables
pins for damage, replace if required
Possible solutions
Refer to the scale manual
Loosen 4 top bolts on loadbars, if they settle theymay
require a washer in 1 corner
Loadbars may require servicing
25
HD3 Sheep Handler Installation Manual
1214-V1