Operational Modes - Te Pari Racewell HD3 Installation And Operation Manual

Racewell HD

OPERATIONAL MODES

Mode 1 Normal operation mode, best for most tasks like crutching, ear marking,
weighing etc This mode is the default setting at start-up It provides delayed
opening of the entry gate following an animal's release from the crush
Mode 2 Quick throughput for weighing and drafting Best if weighing and auto-
drafting large mobs of animals Mode 2 gives you manual control of the
entry gate By supervising the operation of the entry gate throughput can be
increased because the delay in opening the gate can be reduced
Mode 3 Disables auto-catching and the auto-gate but still allows catching with the
manual controls The "eyes" must be turned off in this mode This allows most
animals to run through but lets you catch the ones you want for dagging etc
To change Modes:
Mode 1 - The default mode Whenever you
Handler will be in Mode 1
Mode 2 - To go to Mode 2,
Racewell HD
Release
Mode 3 - To go to Mode 3,
Hold
Switching
Te Pari - www.tepari.com - FREEPHONE 0800 837 274
Automatic sheep handlers have 3 operational modes
Power Off
www.tepari.com
NZ 0800 837 274
position for 3 seconds while turning the
Power Off
position for 3 seconds while turning the
Power Off then back
SHEEP HANDLING SYSTEMS
Power On
from
then hold the Hold switch in the
then hold the Hold switch in the
Power On
On will return you to Mode 1 from Mode 2 or 3
13
HD3 Sheep Handler Installation Manual
Off
the
The Hold Switch
Up to HOLD
Power On
Down to RELEASE
1214-V1