Operating Instructions; Connecting The System; Start Up/Shut Down - Hotronix MAXX Operator's Manual

Digital clam
Table of Contents

Advertisement

HOTRONIX
THE MAXX

Connecting the System

Connect the power cord into a properly grounded electrical
outlet with a sufficient amperage rating.
Voltage
120 volt requires a full 20-amp grounded circuit.
240 volt requires a full 10-amp grounded circuit.
Extension Cords
should be as short as possible and not
less than 12 gauge. Heavy duty cords are recommended.
Circuits
with less than 15 amps or that have other high
demand equipment or heat presses plugged in should not
be used.
Note: If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified person in
order to avoid hazard. Use SJT type rated 300 V cord for replacement.
CAUTION
Failure to follow these instructions will cause:
1. Erratic controller functions.
2. Inaccurate displays and slow heat up.
3. The circuit breaker to disengage.
6
SERVICE HOTLINE: 800.727.8520
®
PRESS
®

Operating Instructions

Start Up/Shut Down

Locate the lift handle and position the heat platen in the
UP position.
Locate the Power ON/OFF Switch on the side of the press,
then turn the Power Switch ON.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MAXX and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents