Table of Contents
Advertisement
INSTALLATION
Improper assembly may result in water
damage to electrical components and unsafe
conditions. The manufacturer is not responsible for
damage cause by improper re-assembly of these
parts.
Quartz Sleeve Assembly Includes:
1. Quartz Sleeve
2. White Quartz Sleeve Retaining Nut
3. Rubber Gasket
4. Clear Quartz Sleeve Module
5. Clear Quartz Sleeve Module O-ring
6. Power Supply Gasket
Assembly Instructions
1. Position the white quartz sleeve retaining nut and
rubber gasket over the open end of the quartz
sleeve.
3. Slide the "open-end" of the quartz sleeve (with nut
and gasket in position) into the clear quartz sleeve
module.
3. Thread the white retaining nut onto the clear quartz
sleeve module's male threads and hand-tighten.
4. While hand-tightening the white retaining nut onto
the clear quartz sleeve module, use your index
finger to ensure that the open-end of the quartz
sleeve mates smoothly with the inside lip of the
clear quartz sleeve module; this signifies a good
fit. See Photo A.
5. With the quartz sleeve positioned inside the
clear quartz sleeve module properly, finish hand-
tightening the white retaining nut. When the white
retaining nut is tight, the quartz sleeve should
appear straight inside the clear quartz sleeve
module (see Photo B).
NOTE: If the quartz sleeve appears crooked it may
leak. Disassemble and try again.
6. Carefully slide the quartz sleeve assembly into
the UV vessel (see Photo D). The domed-end of
the quartz sleeve should slide into the coupling
located on the non-electrical end of the UV vessel
(see Photo C).
7. With the quartz sleeve assembly properly in place,
the quartz sleeve retaining module should sit flush
against the top of the UV vessel. See Photo E.
NOTE: Be sure that the clear quartz sleeve module
O-ring and gasket is properly seated in the bottom
of the quartz sleeve module (see item #6 on page 4).
SMART UV® UV DISINFECTION STERILIZER Installation and User's Guide
9
Hide quick links:
Advertisement
Table of Contents
